https://docs.mitigator.ru/v26.04/en/tags/policy/ Recent content in Policy on BIFIT Mitigator Hugo -- gohugo.io en https://docs.mitigator.ru/v26.04/en/kb/quick-setup/ Mon, 01 Jan 0001 00:00:00 +0000 https://docs.mitigator.ru/v26.04/en/kb/quick-setup/ The materials in this article are intended to facilitate understanding of the protection organizing basic principles using MITIGATOR. Below is an example of setting up the system in the first iteration. First, all packets are processed in “General Protection”, then 5-tuple routing rules distribute traffic to protection policies, and after the policies, the traffic returns to “General Protection” for the remaining countermeasures. Processing of back traffic from the protected resource is not considered in this article. https://docs.mitigator.ru/v26.04/en/kb/policy-checklist/ Mon, 01 Jan 0001 00:00:00 +0000 https://docs.mitigator.ru/v26.04/en/kb/policy-checklist/ List of steps Make sure the routing rules for the policy are set. Configure the policy to display only the necessary countermeasures. Set up countermeasures. Set up automatic packet capture. Set up autodetection. (Optional) Check the effect on legitimate traffic via the test mode. Enable protection policy. (Optional) Configure the log analyzer. (Optional) Pin countermeasure graphs. Details 1. Make sure the routing rules for the policy are set. Make sure that the routing rules are set for the policy on the “Policy Setup” tab of the “Protection policy” page.