https://docs.mitigator.ru/collector/v26.08/en/install/System Requirements Processor with hugepages support and SSE 4.2 (at least four cores). At least 16 GB of RAM. At least 1TB of free disk space. To estimate the required hard drive capacity, use the table below. Single Record Estimate FPS Storage Capacity Conservative (44B/record) 10Kfps 1TB = 28 days, 1.1TB/month 50Kfps 1TB = 5.5 days, 5.5TB/month 100Kfps 1TB = 2.8 days, 11TB/month Averaged customer data (21B/record) 10Kfps 1TB = 47 days, 0.65TB/month 50Kfps 1TB = 9 days, 2TB/month 100Kfps 1TB = 4.7 days, 6.5TB/month Calculate hard drive capacity with a safety margin. You can estimate the space occupied in ClickHouse using this guide.Hugoenhttps://docs.mitigator.ru/collector/v26.08/en/install/vpn/Mon, 01 Jan 0001 00:00:00 +0000https://docs.mitigator.ru/collector/v26.08/en/install/vpn/Collector and MITIGATOR interact via Wireguard. Collector has a key pair: a private key and a public key, like every MITIGATOR instance. The private key is stored only on Collector in vpn-private.conf. The public keys of all VPN nodes are listed in vpn-public.conf, which must be the same for all nodes. VPN Collector address is specified as COLLECTOR_VPN_ADDRESS in .env. The VPN uses port 4567 (UDP) by default. This port number can be changed via COLLECTOR_VPN_PORT in .env.https://docs.mitigator.ru/collector/v26.08/en/install/bgp/Mon, 01 Jan 0001 00:00:00 +0000https://docs.mitigator.ru/collector/v26.08/en/install/bgp/You can use gobgp from our docker registry if you need to announce prefixes via BGP. Setup of BGP speaker gobgp is available on port defined by the environment variables: COLLECTOR_BGP_PORT (default: 179) Setup instruction: Create folder config/gobgp and configuration file config/gobgp/gobgpd.yml. Set settings into config/gobgp/gobgpd.yml using documentation. For example: global: config: as: 64512 router-id: 192.168.255.1 neighbors: - config: neighbor-address: 10.0.255.1 peer-as: 65001 - config: neighbor-address: 10.0.255.2 peer-as: 65002 Add gobgp module into docker-compose.override.yml. If docker-compose.override.yml is absent you need to create it.